The GTi Coils from Vaporesso are built for direct to lung and ideally suited to high vg eliquid above 70VG Using a push fit design they are simple to install and are compatible with the Vaporesso iTank and Vaporesso iTank 2. The GTi mesh coils use corex technology to maximise flavour. Usually a mesh coil will heat mostly in the middle section of the mesh concentrating the heat on one area of the wick. With the corex morph mesh coils 80% of the mesh is heated making the most of the saturated wick meaning less dry hits and more flavour.

Compatible with

Vaporesso Target 100 kit, Vaporesso Target 200 kit, Vaporesso iTank, Vaporesso iTank 2, Vaporesso Gen 200 with iTank 2 and more 

Its very important to prime all vape coils before use for best results in terms of flavour, how long they last and to not burn them too quickly 

Notes on Priming your GTi coils

• Always prime your coils well when using for the first time
• Add 5 or so drops to the centre of the coil saturating the cotton that's touching the mesh
• Reassemble the tank making sure push the coil so it is secured in place
• Add your chosen liquid to the tank making sure to leave a pea sized air bubble of space at least
• Take 5 or so long drags on your tank without powering the coil (this pulls liquid into the wick starting the wicking action)
• To be absolutely sure leave rested upright for a minute or so. Although if primed correctly shouldn't be necessary
• Start the power at the lower end of recommended wattage and turn up to taste

For more information and tips on making your coils last longer and taste better see our blog 

GTi Coils Resistances and Recommended wattages

• 0.15ohm mesh - 75watts to 90watts 
• 0.2ohm mesh - 60watts 70 75watts
• 0.4ohm mesh - 50watts to 60watts 
• 0.5ohm mesh - 30watts to 40watts

GTi Coil Dimensions

21.65mm height by 13.3mm width

GTi Coil Pack Contents:

• 5 x Gti Mesh coils per pack