Geek Vape Q Pod Cartridges are a replacement cartridge for the Weenax Q and Sonder Q pod kits from Geek Vape. 2ml capacity that can be filled easily by removing the mouthpiece cap and filling through the hole.

We recommend using 50pg 50vg liquid for best results that can be Salt nicotine or Freebase nicotine  

Please note: With all coils and pods it is essential that you prime them before use.

Priming Guide

1. Remove the pod from the battery.

2. Fill up by removing the lid of the pods, making sure you don't fill too high. Always leave room for a small bubble of air as over filling can lead to leaking. 

3. Do not put the pod in the battery yet. Before putting the pod in the battery take 4 or 5 draws on the pod to help pull e-liquid into the cotton wick of the coils to get them ready for use

3. Leave the pod to sit for a minute before you start vaping to make sure the pod is properly saturated inside.

Common mistakes when priming a vape.

1. Filling to the brim which can cause the coil to flood leading to spitting or leaking. 

2. Removing the cap several times after filling. This can result in the same as no 1 

3. Filling and leaving without taking the puffs without the pod/coil connected to the battery. Often an air bubble can sit in the coil and stop the cotton wick saturating leading to the first powered puff burning the coil, or the bubble bursting causing all of the liquid to leak from the device. The priming puffs before connected to the battery creates the right vacuum in the tank for it to wick correctly. 

4. Taking primer puffs to desaturate the wick whilst on the battery or powered. This can instantly burn the wick. 

Recommended Wattages

• 0.6ohm - 18w to 25w
• 0.8ohm - 12w to 18w
• 1.2ohm - 8w to 12w

Features:

• Recommended to be used with 50pg 50vg
• Pack of 3 refillable pods
• Top Cap Refill
• 2ml capacity
• Integrated Mesh Coil
• 0.6 Ohm, 0.8 Ohm, 1.2 Ohm

Contents:

• 3 x Q pod cartridges